by jwhitmor » Tue Mar 10, 2015 9:27 am
Ludwig,
Check the printed dimensions on your printed paper template with a tape measure. The dimension labeled 10" should measure 10" on your paper template (other dimensions - etc.). If it does not, then you cannot use your printed template to mark the drill locations. Some things to try: print the template with "landscape" selected using A4 or U.S. letter size paper (or larger). Check the scaling option for the printer. It should be set to: "off" or "100%". Do not use "shrink to fit", "scale to page", "page protection", or anything similar.
If it is not making X-rays, your B+ is too low.