Great! I was worried about the 6.3 amp rating at 6amps being too much for the filaments. So the PS valves in the BOM will work as they are? I haven't tried the setup in PSUDII yet. I'll try it with and without the R21 100Ω 3W if it will let me.
I have a bunch of Kiwame resistors too but they might be to big for the PCB (2W). The valves of R3-R4, R13-R14 grid stoppers are 1kΩ. Can these be upped to 1.5K? Also for the R1-R2 I have some 470K Kiwames. If these wont work I'll just order from mouser.
I checked the link to the mouser BOM. The .22 coupling caps and the R23 330k are not available. I have some .22 k42y Russian caps. I couldn't find the 330kΩ resistor on the schematic? While searching the threads I saw that you were updating the BOM. Should I wait to order from mouser?
Lots of questions.
Mark