Hi,
I modified the description. Through currency fluctuations prices are stated in Euro.
Unfortunately, I do not work with cocobolo.
toti
Ritchie wrote:Do you have any chassis for st35 board?
Thanks,
Ritchie
Geek wrote:A customer comes into my store all excited... "Gregg, look at the chassis I found and it fits your DynaMutt perfectly!"
You're getting pretty famous!
On the top Stainless Steel sheet are pre-drilled holes for Dynaco ST70 with Diytube driver
EWBrown wrote:From the first posting:On the top Stainless Steel sheet are pre-drilled holes for Dynaco ST70 with Diytube driver
tomlang wrote:Here is a .dxf of the tubesforhifi vta board FYI that I measured off a board a while ago. It also has holes to drill for the bias pots if you utilize stand-up multi-turn pots and not the laydown single turn specified.
This is a .dxf file. To use it replace doc with dxf. I can't upload a dxf so have to fool the bulletin board.
tomlang wrote:Hi, are you getting the chassis top plates laser cut? Can you fabricate just the top plate?
For information, I am attaching a draft design for a top plate for a metal chassis I already have. It is an 18 inch by 13 inch size top plate. Can you provide an estimate of this cut in aluminum and stainless steel? What about shipping costs to Georgia, USA?
Thanks!
Users browsing this forum: No registered users and 34 guests