TomMcNally wrote:Anyway - I have a nice 17 x 12 x 2 chassis sitting around, and was thinking of mounting Shannon's ST-70 board below deck, and using the AA-100 transformers and the new 7591's and building a nice ST-70-type clone for my next project. Has anyone done this ? Any thoughts ?
TomMcNally wrote:The power supply is the easy part - cutting the holes for the output transformers is the hard part !
TerrySmith wrote:The problem with that is they are hard to come by. Maybe Uncle Ned could get them from his supplier?
separks wrote:TomMcNally wrote:The power supply is the easy part - cutting the holes for the output transformers is the hard part !
Eric Hayes mentioned a reinforced Dremel cutting wheel in another thread (not the thin stock kind that shatters everywhere or burns out after a minute of use). That might be worth looking into if you have a Dremel-type device.
Users browsing this forum: No registered users and 2 guests