I am in the powersuppy design stage for a 6V6 based SET
You can see a rough idea of what I am doing in this schematic. Ignore the part list and specifications, none of it was calculated, I am just using this topology and copied the schematic.
http://dortoh.ca/crap/simpleset.jpg
This is the PSU I have got so far:
http://dortoh.ca/crap/simpleset.psu
I am using PSUD2 to design a power supply and am stuck with calculating the load that will bw drawn. The input will be handled by a single 6SN7 and the output will have a 6V6 on each channel for 3 tubes in total.
180V for the 6SN7 and 250V for the 6V6's.
Anyone have any pointers?