Fender 5E3 build - second set of eyes needed

a fine line between stupid and clever

Fender 5E3 build - second set of eyes needed

Postby rrrber » Wed Dec 29, 2010 4:29 pm

Hello All,

I've been working on my second build and am getting ready to install the circuit board into the chassis. It would be much appreciated if anyone who has experience with this amp can take a look at my pictures and act as a second set of eyes before I proceed. I'll be reviewing everything myself but its always good to have others looking at the same thing in case I miss something.

The AC and Filament wiring all checked out ok in that all of the tubes fired up when I put them in one by one. Have taken no measurements yet.

Any other advice at this stage of the build would be appreciated as well.

You should be able to get to the photo album from the link below.

Thanks again.

http://s109.photobucket.com/albums/n75/ ... -33_51.jpg
rrrber
 
Posts: 1
Joined: Fri Apr 17, 2009 3:35 am
Location: CT

Return to guitar amps

Who is online

Users browsing this forum: No registered users and 9 guests