Assembled this amp into a solid state chassis. New Weber PT and OT.
The PT is the international version. I'm using the brown 120V tap on the primary.
The tubes light up, but I am getting zero sound out of the speaker.
Not even a faint hum. I must have done something incredibly stupid, but I can't see what.
I'm not getting any DC voltage at the filter caps. I swapped rectifiers, same result. I have the primary center tap of the OT at pin 8 of the rectifier.
I'm using red/red (680V) off the PT into the 5Y3. Should I be using this, or the 540V? Seems like something ought to happen!
I know, I should have started it with a light bulb current limiter, but I haven't built one. Too lazy, or overconfident.