Just a heads up for those of You building a SDS Cap Board. When I applied power to my new cap board last night there were four small pops then smoke came rolling out. I checked the caps four times when I assembled so what's the deal? After some investigation and sharp eye on the flukes range, I found that the bleeder resistors were 330 ohm NOT 330K ohm Yellow_Light_Colorz_PDT_13 . The low resistance also takes out the 6.8k (R1). So if you are building a new SDS cap board check the bleeders before installation. I'll see what Triode will do, because when I received the kit it was missing the 22k (R2). I called triode to order more parts and they said we'll ship the resistor with your order. When the order arrived guess what no 22k Yellow_Light_Colorz_PDT_21 . Oh well.
Now (impatiently) on to the spare parts box.......
Ted