petercapo wrote:.... cross-checking with the other manual http://www.diytube.com/st70/diytube_st70_B.pdf to see if there is any difference in the way the instructions are expressed.
petercapo wrote:.... a wire can go from the PCB to lug#6 with the resistor then going from lug #6 to #5. These were the ways it was done in the original Stereo 70 and is what I got from looking quickly at the DIYtube manual - hope I am not giving you a bum steer here - perhaps someone else can confirm.
petercapo wrote:With regard to the Triode USA cap board, it does not eliminate the 5AR4 tube rectifier. The single diode on the Triode USA cap board is for the bias supply.
petercapo wrote: Triode USA cap board, it might be necessary to adjust the series of resistors along the B+ to get the voltage levels right for the DIYtube Stereo 70 driver board. When you are finished building it, take some voltage readings and compare it with the reference values in the manual.
TomMcNally wrote:.... resistors would be crossed as shown, and hook to pin 5 of the tubes. Pin 6 would be unused.....
Users browsing this forum: No registered users and 100 guests