Simple Question
Posted:
Sat Apr 20, 2013 12:53 pmby pmarcin
I'm selling a Rev B version of the ST70 board that I won't be using. I'm assuming the implementation still requires the crossover of the wires from j1, J2 and J22,J23. Is this correct? I have several versions of the documentation and one spells this out in very large font, bold letters. I'm including this page with my documentation. In others, the steps are detailed. (Actually, J1 and J2 are reversed in position from 1 and 2 in the stock ST70.)
Re: Simple Question
Posted:
Sat Apr 20, 2013 1:21 pmby Shannon Parks
You are correct. It slipped past me in the prototype phase, and I never corrected it as it required a lot of layout changes. So all diytube ST70 boards require the 'X' wiring.
Shannon
Re: Simple Question
Posted:
Sat Apr 20, 2013 1:48 pmby pmarcin
Thanks, Shannon. I just wanted to make sure my documentation was correct, I have three different versions of the documentation and one doesn't include installation. I included the single page warning so the next person won't make the mistake.
P.S- I really like the Budgie SE and MM.
Great work..