DIY Tube Driver Board
Posted: Wed Apr 04, 2012 9:55 am
Hi Shannon,
Can you advice what is the input sensitivity of your driver board?
Thanks!
Can you advice what is the input sensitivity of your driver board?
Thanks!
new registrations are closed at this time
http://www.diytube.com/phpBB2/
separks wrote:Referencing back to my manual, I see it took 1.06Vrms for 35W output and 1.165Vrms for 42W (1%THD) - so basically 1Vrms.
http://www.diytube.com/st70/diytube_st70_B.pdf
Shannon
separks wrote:Depending on your source, yes, you can just use a 100K volume pot. CD players will drive it easily. And devices like iPods are usually 1Vrms max output so you should be fine, though your volume pot will be cranked as well as the iPod volume control - but that isn't a problem.
Shannon