I'm a bit of an amateur, so please be kind to me! When biasing the ST70 with DIY board installed as per the instructions, I reach a bit of a problem... After dialing in 400mV on both sides with no trouble, and balancing the outputs using the balance pots on the driver board to 0 volts, flat, I reach item "5" on the instructions, stating "adjust to 500mV...using the Dynaco wire-wound pots". My problem is here- when turning the left pot up, I run out of turn at about <>480mV. No more pot to turn...The right dials in 500mV without trouble. Any ideas? I know I'm dealing with pretty small differences here, but there's nothing wrong with perfection in my book!
Any help would be greatly appreciated. I should note that this amplifier works perfectly and sounds awesome.