Hey everyone.
I'm perfoming a complicated (for me) upgrade of the PCB for my ST70. I'm using the VTA board and trying to follow the directions, but I'm getting confused with them:
1) The instructions that came with the VTA board say to connect the 2nd & 3rd section of the quad cap with a piece of wire and to replace the 22k resistor between the 1st & 2nd sections with a 2.2K resistor...
BUT:
2) the directions at the VTA installation page say:
"the 6.8K and 22K resistor on the quad cap can be removed and thrown away. The 2nd, 3rd, and 4th section of the quad cap can be connected together with a piece of wire. The choke will remain connected to the 1st and 2nd section of the quad cap." No mention of the 2.2K resistor.
HOWEVER:
3) the accompanying photos at the same website show a connection not between the 2nd & 3rd section of the quad cap, or even the 2nd, 3rd & 4th sections, but the 1st, 4th & 3rd sections. No mention of the 2.2K resistor here, either.
Here's a helpful pictoral from the same VTA site of the last quad cap wiring scheme I've mentioned, this time including a 2.2K resistor between the 3rd & 4th sections.
Can someone who's installed the VTA driver board help me out here?
Best,
Benjamin