All,
So I have this factory wired ST70 sitting here.....And I don't think I really want to change it (as I think I should do OK with it on ebay Yellow_Light_Colorz_PDT_05 )
My question is this - below is a list of the items I purchased to replace on the origional ST70, along with a couple of items I know I will require. What else am I missing ? I am using Shannon's board, along with an SDS Cap board (so no need for any of the bias pieces). I know there are some bias resistors on the tubes, as well as some others around. Any help would be GREATLY appreciated !
I have or know I need:
1 - Chassis from Triode
1- PA060S
2 - A470
1 - C354
1 - DIY Tube Driver board and components
1 - SDS Cap Board and components
5 - Octal Sockets
2 - Isolated RCA Jacks
1 - Power Cord
1 - On/off switch
1 - Fuse Holder
2 - 10k Bias Wipers
6 - Binding Posts
Misc screws/bolts for the chassis and tube sockets
Various Teflon Wire
So - I believe all that I need now are:
2 - 15.6 ohm bias resistors (I think I still need these....)
4 - 1k resistors for the grid stoppers
Does that sound about right ?
Thanks again !
Steve