diytube.com

**SOLD!**

I received this chassis a few years back and always planned on making a Hi-Fi amp out of it. Life got busy and I don't see myself getting to it anytime in the near future.

It had two EL84's, an EF86, and a 12ax7 per channel.

The OT's are made by Quality Transformer & Coil Company, Chicago IL. Model 6-W-17. The are labeled as 12W and have UL taps on the primary side and 4, 8, and 16 ohm taps on the secondary. I measured the primary impedance a while back and got around 5.7K

I don't recall the PT voltages now, but can report back on that. I do know that I tested each tap and the PT is working.

I know I swiped some parts (coupling caps, etc) out of it to finish another build. So this is being sold untested, not working and as-is. I have no tubes for it either.



Pictures here:

https://www.dropbox.com/sh/rayegwj9uyd3 ... ps7va?dl=0

Thanks for looking!

Brandon Ankeny

What are the dimensions of the chassis, also the cage, thanks.

The chassis is 12" x 10" x 3". It's 9" tall with the cage on. I have no bottom plate.

...so was it set up to use two 5y3(rectifier)??

I'm not sure. I received it with no tubes. There are two holes in the chassis where a rectifier might go, but only one socket.

SOLD!