I have a 1kv transformer that has two 6.3V taps.
I'm not sure what to do with it, and then after a few cold beverages, it hit me that since it was wired for 115 and 230V mains that I could just shift my wall supply from the 115v tap to the 230 and it would essentially make me a 500VCT with two 3.15V windings where I could use the wires where I series them as a center tap.
Can I do this without any damage to the transformer?
Any source frequency issues, or is 60Hz ok into the 230V line?
Does it make sense at all is a better question;))
Thank you!
Blair