Some fun tube amp toys.
Posted: Tue Dec 10, 2019 8:14 pmSo, I have a really good laser cutter. I made a strong press fit cap holder out of quarter inch plexi. It holds really tight! Check it out.
Ok, this next one is for us old dudes. I can now read the pin numbers..... Boooo yah!
I made a relief cut in case I want to snap them out after testing an break in, but I kinda like them!
In fact the whole case was cut out of laser cut 1/4" ply glued together covered with veneer.
It allows me to pre cut all holes for stuff.......
Ok, this next one is for us old dudes. I can now read the pin numbers..... Boooo yah!
I made a relief cut in case I want to snap them out after testing an break in, but I kinda like them!
In fact the whole case was cut out of laser cut 1/4" ply glued together covered with veneer.
It allows me to pre cut all holes for stuff.......