Shannon, these transformers are the same size / weight as the CXSE25's tour using on the 300B amp so the 3mm plate should be more than enough.
HF-89 clone?
17 posts
• Page 2 of 2 • 1, 2
Re: HF-89 clone?
by TerrySmith » Fri Mar 22, 2013 9:47 am
Got my iron from Edcor, time for a trial fit. Tomorrow I'll be drilling and punching, and rolling the dents out of one of the transformers. I'm liking the layout in the first two pics. The 12ga chassis will hold all this weight quite well.
Shannon, these transformers are the same size / weight as the CXSE25's tour using on the 300B amp so the 3mm plate should be more than enough.
Shannon, these transformers are the same size / weight as the CXSE25's tour using on the 300B amp so the 3mm plate should be more than enough.
T. Smith
-
TerrySmith - KT88
- Posts: 973
- Joined: Sat Jan 31, 2004 12:51 pm
- Location: Maryville TN
Re: HF-89 clone?
by Shannon Parks » Fri Mar 22, 2013 10:36 am
TerrySmith wrote:Shannon, these transformers are the same size / weight as the CXSE25's tour using on the 300B amp so the 3mm plate should be more than enough.
Cool, and looking good. I'll get getting one of those PP outputs, too, for my 100W Ike KT120 monoblock project in a few weeks. I need to finish up the 300B project so I can focus on that one! Not enough time...
Shannon
- designer of fine tube audio gear at (((parks audio)))
- founder and admin of the diytube forums
-
Shannon Parks - Site Admin
- Posts: 3764
- Joined: Tue Mar 18, 2003 5:40 pm
- Location: Poulsbo, Washington
17 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 63 guests