Shielded feedback loop
Posted: Mon Mar 02, 2015 8:34 pm
I'm stuffing the board on my budgie and I have a question about the shielded jumper for the feedback loop. From the photo, It appears that I make some connection to the + and a - terminals at both ends.
Obviously a signal wire runs between the two + terminals. I can imagine three options with regard to the two - terminals:
1) signal wire connected at both - terminals and the shield at only one
2) signal wire and shield connected at both - terminals
3) only the shield that is connected at - terminal with no signal wire?
Is there one thats preferred?
Sean
Obviously a signal wire runs between the two + terminals. I can imagine three options with regard to the two - terminals:
1) signal wire connected at both - terminals and the shield at only one
2) signal wire and shield connected at both - terminals
3) only the shield that is connected at - terminal with no signal wire?
Is there one thats preferred?
Sean