Page 1 of 1

Mode switch advice please.

PostPosted: Sat Aug 10, 2019 7:46 am
by GrahamJ
I'm hoping to fit a Triode/UL switch to my Budgie SE.
There is a lot of information online about mode switches but not many diagrams. As I find diagrams easier to understand I have sketched up what I think is suitable in the hope that a member, far more knowledgeable than me, would check it over and advise, as necessary.

Image

Thanks

Re: Mode switch advice please.

PostPosted: Tue Aug 13, 2019 12:21 pm
by GrahamJ
Just found a good diagram for the mode switch produced by George of Tubelab.com.
For his SSE KT88 amp he has fitted the 100R resistor between G2 (pin 9) and the switch.
Now I'm confused? (???)

Re: Mode switch advice please.

PostPosted: Sun Aug 18, 2019 1:55 am
by GrahamJ
Sorted. I have been advised to follow the advice in the previous post. Ignore my diagram.
Additional information received included keeping the resistors and the switch close to the PCB and the necessary wiring runs short.
:$