Audiophyle wrote:So I am in the middle of soldering the parts onto the Budgie board & I noticed that the resistors for R1,R2,R11,R12 are listed as 475kohm 1/2W on the schematic, but the parts in the Mouser BOM are 475Kohm 1/4W.
Also R7 & R8 are listed as 100ohm 1/2W but the Mouser BOM contains 1/4w 100ohm resistors.
Can I use the 1/4W resistors or should I reorder & replace them with the 1/2W as indicated by the schematic?
(fingers crossed the 1/4w will be fine)
Audiophyle wrote:Ive got another quick question.
The on/off switch is rated for 16A 250VAC, but I found a switch I really like that is only 5A 250VAC.
Can I run the lower rated switch? Or should I stick to the 16A capacity?
Audiophyle wrote:Do you think the noise would be picked up from being in close proximity to the DC inverter, ...What if I were to isolate the DC inverter inside the amp chassis with a thin copper casing, a makeshift Faraday cage grounded to the chassis & insulated from both the amp & inverter?
Audiophyle wrote:I'm also curious, if I am using the analog headphone output from my iPhone can I eliminate the volume pot from the budgie & instead rely on the iPhone volume setting to control overall volume? I would probably keep a pot in circuit, but mount it inside as more of a gain control VS a volume knob. Thoughts?
Users browsing this forum: No registered users and 1 guest