Ohm out
Posted: Tue Sep 13, 2005 8:08 am
Hey guys,
I have my first ike built and ready to fire up, but I have some questions.
1. Everything ohms out EXCEPT pin 7 of V1 (12ax7) I am getting 480k instead of the 23k in the chart AND J4-6 & 7 says 40 ohms and I am getting closer to 800 or 900k.
These are with tubes in and trannys hooked up.
2. The switch wiring in schematic does not seem to match up with the note. There are 3 pins on the switch, but only two are shown in the schem?
could anyone shed some light on this?
Thanks so much!
Marshall
I have my first ike built and ready to fire up, but I have some questions.
1. Everything ohms out EXCEPT pin 7 of V1 (12ax7) I am getting 480k instead of the 23k in the chart AND J4-6 & 7 says 40 ohms and I am getting closer to 800 or 900k.
These are with tubes in and trannys hooked up.
2. The switch wiring in schematic does not seem to match up with the note. There are 3 pins on the switch, but only two are shown in the schem?
could anyone shed some light on this?
Thanks so much!
Marshall