Milliamp meter for biasing Eiclone Rev. B

a DIY, modified Mullard 5-20 monoblock design

Milliamp meter for biasing Eiclone Rev. B

Postby hilldweller » Sat Dec 14, 2013 5:05 pm

This may seem like an elementary question but here it goes, If I wanted to read actual current draw for each power tube in the bias circuit. How would I connect the milliamp meter to the rev b boards as opposed to the voltage bias method? I know it would have to go in series with the load but I am not clear as to how to connect to the board. Thanks
Analog is Real! Experience it!
Digital leads to trans humanism. Not good.
User avatar
hilldweller
KT88
 
Posts: 285
Joined: Wed Aug 01, 2007 5:28 pm
Location: St. Louis Missouri USA

Re: Milliamp meter for biasing Eiclone Rev. B

Postby IGGY » Sun Dec 15, 2013 5:36 pm

;) Hello ,

I connected my with digital volts meter (read out 0-9 vdc) easy to read out and just connect to p1 and p2 on the pcb. I love it.

Regards,
Iggy
User avatar
IGGY
 
Posts: 81
Joined: Wed Nov 21, 2007 6:22 pm


Return to eiclone

Who is online

Users browsing this forum: No registered users and 13 guests

cron