by Kojak » Sun May 25, 2008 1:33 pm
FYI, below string from Tube 101, posting replies here for reference...
Posted: Sun May 25, 2008 10:22 am Post subject:
--------------------------------------------------------------------------------
I would assume looking at the schematic, that it's grounded.
What does it do on the circuit board ? Aren't J-4 3,4,5 all connected
together on the board ?
... tom
Back to top
Kojak
Joined: 22 Feb 2008
Posts: 17
Location: Nashville, TN
Posted: Sun May 25, 2008 10:33 am Post subject:
--------------------------------------------------------------------------------
Yes, they are all connected to ground on the board side. Go ahead and connect J4-4 to chassis ground?
Back to top
TomMcNally
Darling du Jour
Joined: 19 Nov 2005
Posts: 1281
Location: Northfield, NJ
Posted: Sun May 25, 2008 1:15 pm Post subject:
--------------------------------------------------------------------------------
It can't hurt ... you want to only ground to the chassis at one point.
Back to top
Kojak
Joined: 22 Feb 2008
Posts: 17
Location: Nashville, TN
Posted: Sun May 25, 2008 1:31 pm Post subject:
--------------------------------------------------------------------------------
OK, thanks Tom. I wasn't sure if the board was supposed to ground through the mounting stand-offs. Other than that, this should be the only point.
best, Ed