ike pix
Posted: Sun Dec 14, 2003 9:02 pm
Geez, I realize this project has gone on forever, but I'm actually editing the assembly guide at this point. Almost there.
The big hole up front is bias control. The spare octal socket is for future tube rectifier testing. I recommend using two inch high chassis for the production units - I just happened to have a couple of these aluminum 12X8X3s laying around.
Shannon
The big hole up front is bias control. The spare octal socket is for future tube rectifier testing. I recommend using two inch high chassis for the production units - I just happened to have a couple of these aluminum 12X8X3s laying around.
Shannon