So I finished my 6L6 tonight... Finding a CL90 to add to the mix.
My budy put it on his bench and the amp has a pretty wave form... very very clean, even till clip.
Parts used:
Edcor XPWR005-120
GXSE15-8-5K
C354 Choke
The amp is putting out 3 watts rms before clip, and can be drive to full output via an iPod... ~450mv i think. As this is my replacement office amp, being able to drive this bad boy with low output sources rocks!
Ive checked all the voltages and there are either spot on or +/- 5%.
120v in 116v after the cl90 to the power transformer.
Has anyone removed R15/ R16 for increased output...?
So UL + Feed back = more output but needing more drive
My setup of triode, no feedback is super easy to drive, but only 3watts.
Would 3.5k transformers been a better choice?
Bunch of comments and questions... hope everyone likes the product... I sure do.
I still love my GetSetGo 300b best... but this is a definit charmer.