Ty_Bower wrote:The lead spacing ought to be the same as the ones in the recommended BOM. I checked the data sheets. It's 3.5mm spacing for the little guy, and 5mm for the bigger one. I think I'll go grab the board and a ruler and verify. The Wima cap has 22.5mm spacing, which I think will fit neatly into the innermost holes on the board.
Ty_Bower wrote:No other comments on the use of the Schottky diodes for the voltage doubler in the heater supply? To be honest, I'm not sure I fully appreciate all the pros and cons. I just know they are used in the GetSetGo, so I figured they would be appropriate here.
Ty_Bower wrote:Question on the fuse (for the whole Darling Clementine) - is 1/2A, slow blow about right? I'm guessing 650mA @ 12.6V, plus 52mA @ 280V is less than 23VA, so the whole amp is less than 1/4 A draw from the line.
Users browsing this forum: No registered users and 62 guests