Help on cab/amp switcher
Posted: Sun Jan 17, 2016 9:20 am
Hi!
I have two 50W tube amps and I want to connect them to a cabinet – only one amp at a time. The other amp should be connected to a 16 ohm dummy load at the same time (four 4 ohm power resistors in series, each 50 W).
Can I use a 4PDT toggle switch to do this and would it work as shown in my image?
Of course I would switch both amps to standby while flipping the 4PDT switch.
I have two 50W tube amps and I want to connect them to a cabinet – only one amp at a time. The other amp should be connected to a 16 ohm dummy load at the same time (four 4 ohm power resistors in series, each 50 W).
Can I use a 4PDT toggle switch to do this and would it work as shown in my image?
Of course I would switch both amps to standby while flipping the 4PDT switch.