diytube.com

This one is using 6A3's, makes a future mod to 300B's easy, just add two resistors to drop the filament voltage.
I used Edcor XPWR005 Power/GXSE15-8-3.5K outputs, Hammond 156R choke.
I used an Alps 100K volume control on a handy little Euro-connector board. Makes it very easy.







Hundreds of other amps at http://tmamps.com

... tom

I think Shannon's GSG should be voted into a Hall of Fame for one of the best DIY tube amps

As always Tom, very elegant and tidy work.

Do tell, where did you get that "handy little Euro board"?

Beautiful

The Alps board comes either as a bare board, or with the pot already attached (I got a few of them)

http://www.ebay.com/itm/400512697667?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

Go into the store and look at all the deals. Soldering to a board without the screw terminals would be better
than the tiny leads on the pot itself.

I changed the power transformer to a Dynakit Parts PB=028-1 for 220 volts.
The amp is on the way to Chile. Thanks Nelson (npuas on here)

Thanks Tom, It was love at first sight!