Yet another get*set*go

[TomMcNally]

This one is using 6A3's, makes a future mod to 300B's easy, just add two resistors to drop the filament voltage.
I used Edcor XPWR005 Power/GXSE15-8-3.5K outputs, Hammond 156R choke.
I used an Alps 100K volume control on a handy little Euro-connector board. Makes it very easy.







Hundreds of other amps at http://tmamps.com

... tom

[Geek]

I think Shannon's GSG should be voted into a Hall of Fame for one of the best DIY tube amps

[miker]

As always Tom, very elegant and tidy work.

Do tell, where did you get that "handy little Euro board"?

[npuas]

Beautiful

[TomMcNally]

The Alps board comes either as a bare board, or with the pot already attached (I got a few of them)

http://www.ebay.com/itm/400512697667?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

Go into the store and look at all the deals. Soldering to a board without the screw terminals would be better
than the tiny leads on the pot itself.

[TomMcNally]

I changed the power transformer to a Dynakit Parts PB=028-1 for 220 volts.
The amp is on the way to Chile. Thanks Nelson (npuas on here)

[npuas]

Thanks Tom, It was love at first sight!