I'm a total Noob but am trying to educate myself along the way. Always wanted to build my own tube amp and this is it. I have sourced all the parts and tubes except wiring.
I have read through all of the threads here but can't find any recommendations so I am putting the question out there to the forum.
What wire to use for the amp?
I realize that in most cases the wires are going to be the leads from transformers etc. I did see somewhere that there is a recommendation to use 2-conductor shielded wire for the input signal but what the rest?
I am thinking that power wiring should be at least 18awg copper, yes, no?
I have read so much out there on what wire to use for tube amps that I am pretty confused now.
I do have some teflon insulated 20 awg MIL-SPEC silver plated copper but some people say yes, some no that it sounds bright and "etched".
I do realize this is somewhat subjective but in the spirit of guidance for a noobie what sayeth the crowd?
Thanks,
Hugo