I have almost finished my Get Set Go build & have a couple of questions re the wiring... First of I'm a definate Noob & this is only my 2nd amp build... the fist was built some time ago
The circuit diag shows 2&3 at Connector block J6 going to earth but on other build photos I have seen the Power TX 2ndry Centre tap (red & yellow wire) connected up to one of these. What should go to 2&3 at J6 & if the 2ndry tap doesn't go there should I just tape it up?
Secondly on the first amp I built I used a dpdt on/off switch...I don't have one to hand but do have a basic SP switch kicking about...what's the recommended hookup to the power tx primary & fuse to a 3 pin earth IEC connector (50hz/240v)... I want to clarify as I've read put the fuse on the Live side & seen different layouts.
I'll post some pics when I've done.
Thanks
Mike