Jewel lamp in get*set*go?

[RobertWStephens]

Hello! I am gathering parts for my get*set*go. I would like to use a jewel lamp and a separate on switch. I believe I use a 12v bulb in the lamp to keep it from looking like a headlight. Can I tie this in somplace without effecting the circuit? I believe I can connect the ground to J6, 2 or 3. Can I hook into the 6.3v someplace? Please dumb down any responses! I am already enjoying the process. Peace. Robert

[TomMcNally]

Hi Robert ...

I'd say the best bet is the lowest current draw
12 volt bulb you can find, across J4 1 - 2.
Make sure the lamp fixture you use doesn't
ground one side of the bulb ... they usually
have a phenolic insulator.

Good luck with the new project !

... tom