Page 1 of 1

Mounting and tube hole locations for the Poseidon board

PostPosted: Wed Oct 31, 2012 9:48 am
by ashok
Hi Shannon,

I just purchased a pair of the Poseidon boards. Would it be possible to get the locations of the mounting holes, and tube holes and their diameters?

My plan is to get Front Panel Express plates made for the build.

Thank you,

Ashok

PostPosted: Wed Oct 31, 2012 11:02 am
by Shannon Parks
No problem, Ashok. If I don't post it tonight, I will in the morning.

Shannon

PostPosted: Thu Nov 01, 2012 4:41 am
by Shannon Parks
Here you go, Ashok. One trick I do is to print a 1:1 from FPE and lay my bare board on it for a double-check.

Board Outline
4.375" by 3.250"

Mounting Holes (.130" dia)
500,62
3875,62
500,3187
3875,3187
187,565
187,2690
4188,2690
4188,565

Tube Holes (.750" with the small one piece ceramic)
3525,1625
1455,1625

Balance Pot Hole (not used on board - estimate of trimmer screw)
456,1469

Shannon

PostPosted: Thu Nov 01, 2012 6:29 am
by ashok
Thank you Shannon. Much appreciated. I will make the FPE files available for the forum once I have created and verified them.

Ashok