12ua7 conversion to 6cg7 buffer?

for Dynaco Mark II/III/IV and DIY PP monoblocks

12ua7 conversion to 6cg7 buffer?

Postby logos47 » Wed May 16, 2012 10:43 am

I have reduced the demand on my power transformer using a 5H Hammond choke input and am planning to install a small switching device to regulate the power supply for the Podiedon driver board tubes. That will further relieve the load on the PT. I am wondering whether a mod can be done with this board so as to accommodate a 6cg7 buffer tube as I'd love to try this. Is this possible and if so, how?
logos47
 
Posts: 25
Joined: Thu Oct 28, 2004 5:31 pm
Location: Knoxville, TN

Return to poseidon

Who is online

Users browsing this forum: No registered users and 7 guests