Mark III project, help and advice needed
Posted: Tue Mar 10, 2009 8:29 pm
I have my SDS and Poseidon boards finished and am ready to start on the amps. My basic knowledge and skill level is as a parts replacer. I'm not so great with schematics but can solder well and follow instructions(for the most part)
I've noticed that my lack of planning has left me without replacements for the two 50uF@75v caps and the diodes to replace the selenium rectifier. Any and all suggestions for the parts will be appreciated.
Other tips, advice and suggestions for completing these amps will be greatly appreciated. I hope everyone here is patient as I'll have many questions as this goes along. My goal is to have these amps up and running by the 28th of this month if possible. This means I'll need to get an oder in for anything else I need as soon as possible so please let me know your suggestions for the diodes, caps and anything else I may need.
Here is what I'll be working with. It looks like someone has already been inside the one to replace part of the can cap.
Any and all help will be greatly appreciated.
Thanks in advance.
I've noticed that my lack of planning has left me without replacements for the two 50uF@75v caps and the diodes to replace the selenium rectifier. Any and all suggestions for the parts will be appreciated.
Other tips, advice and suggestions for completing these amps will be greatly appreciated. I hope everyone here is patient as I'll have many questions as this goes along. My goal is to have these amps up and running by the 28th of this month if possible. This means I'll need to get an oder in for anything else I need as soon as possible so please let me know your suggestions for the diodes, caps and anything else I may need.
Here is what I'll be working with. It looks like someone has already been inside the one to replace part of the can cap.
Any and all help will be greatly appreciated.
Thanks in advance.