Curcio BCS board

for Dynaco Mark II/III/IV and DIY PP monoblocks

Curcio BCS board

Postby rgurney » Mon May 12, 2008 12:44 pm

Is it possible to use the Curcio Auto Bias BCS board with the Poseidon board in a MkIII?
rgurney
 
Posts: 4
Joined: Sun Apr 13, 2008 6:46 pm

Postby rgurney » Mon May 19, 2008 7:00 am

After one week, I've received no replies to this post. Even direct e-mail to Shannon got no reply. Thanks much.
rgurney
 
Posts: 4
Joined: Sun Apr 13, 2008 6:46 pm

Postby TomMcNally » Mon May 19, 2008 7:36 am

Hmmm ... Sorry you didn't get any replies.

To be honest, when you ask a question about something like that,
it would help if you explain what it is, show schematics, and links.

I have no clue what a "Curcio Auto Bias BCS board" is ... but many
of us are very familiar with the Poseidon, and glad to help.

... tom
User avatar
TomMcNally
Darling du Jour
 
Posts: 2729
Joined: Sat Nov 19, 2005 2:19 pm
Location: Northfield, NJ

Postby WA4SWJ » Mon May 19, 2008 2:25 pm

Also sorry you didn't get any replies.

Yes, it should work just fine in the Mark III. I can't quite tell how large the board is from the pictures on the Curcio site, but it looks like it will fit. You will have to change the cathode current measuring resistor values on the output tubes to make it work. Keep in mind the board has the capability to control 4 tubes so two of the outputs will not be used in the Mark III. I see no other reason why it won't work. Caveat - I did not examine it in deep detail. I can do that if needed. So can several of the other guys here.

BTW - there are simpler ways to maintain constant current through the tubes. See this thread:

http://www.diytube.com/phpBB2/viewtopic.php?t=2480

Mike came up with a great way to do that with a three terminal regulator.

Hope this helps. Let us know if you need more info.

Regards,
Ed Long
User avatar
WA4SWJ
KT88
 
Posts: 650
Joined: Mon Dec 27, 2004 8:39 pm
Location: Belleview, FL

Postby rgurney » Tue May 20, 2008 4:52 am

Thanks for your replies, guys. Much appreciated.
I understand that I have to remove the bias injection resistors (100K) (?R12 & R13) when installing the BCS board. Do those traces need to be jumped with wire or just left alone? Do I also need to remove R15 (& R14) - the blue potentiometer? If so, do I need to jump those traces with wire as well? Thanks for your help and advice.

RG
rgurney
 
Posts: 4
Joined: Sun Apr 13, 2008 6:46 pm


Return to poseidon

Who is online

Users browsing this forum: Google [Bot] and 15 guests

cron