Voltage too low?

for Dynaco Mark II/III/IV and DIY PP monoblocks

Voltage too low?

Postby klee » Sun Feb 17, 2008 10:22 am

I am only getting 3v at points D and E on the board instead of the 6.3 specified. Is this a bad transformer? Both of my MK 3's have this reading. They sound good though.
klee
 
Posts: 8
Joined: Wed Jan 02, 2008 8:11 pm

Postby TomMcNally » Sun Feb 17, 2008 10:29 am

It sounds like you are measuring from D and E to ground,
measure across D and E on an AC scale.
User avatar
TomMcNally
Darling du Jour
 
Posts: 2729
Joined: Sat Nov 19, 2005 2:19 pm
Location: Northfield, NJ

voltage

Postby klee » Sun Feb 17, 2008 1:24 pm

Your right I was reading to ground (AC).
klee
 
Posts: 8
Joined: Wed Jan 02, 2008 8:11 pm


Return to poseidon

Who is online

Users browsing this forum: No registered users and 13 guests