Hi All,
I have a question regarding the 6.3 heater connections to the PCB terminal.
My brand new XPWR005 has two yellow and two brown wires for the 6.3 volt taps (note this is different colors than was is referred to in the manual).
Do I wire one yellow and one brown to pin 7 and one yellow and brown to pin 8 OR two yellows to pin 7 and two browns to pin 8?
I am also using these taps to power some LEDS (via bridge rectifier/cap) and I did a quick power check (with the yellow/brown to same pin) and it seems it is not working... retested circuit with battery DC and LEDs still work... already glued 3mm led to socket holes and was glad I didn't burn them out.
Haven't received tubes yet so I haven't had any other issues- but this make me question this -as typical i only have used one set of heater taps in the past.
Thanks for the help.