So I completely dismantled my ST35 with DIYTube driver and EFB mods and came up with a "new" layout. Still working out some bugs but these things happen in 8+ hour marathon soldering sessions. I'm really happy with the new layout and think it will be much easier to measure and tweak. Not to mention I think it looks much better.
Here was my dream. I drew this on my ipad using Paint by 53.
http://i576.photobucket.com/albums/ss20 ... 5229b3.jpg
Next thing you know I got a box and started measuring...
http://i576.photobucket.com/albums/ss20 ... 8fb8a4.jpg
A ton of work later I end up with this...
http://i576.photobucket.com/albums/ss20 ... 87580a.jpg
The IEC receptacle is kinda temporary because I have a hard time cutting square holes in aluminum.
http://i576.photobucket.com/albums/ss20 ... cfb69f.jpg
It's challenging getting a good shot of the inside.
http://i576.photobucket.com/albums/ss20 ... faa030.jpg
Here's a close up of the tube sockets.
http://i576.photobucket.com/albums/ss20 ... 3676a4.jpg
Power supply and EFB.
http://i576.photobucket.com/albums/ss20 ... fffd80.jpg