diytube ST35 reversion (from Rev D back to Rev C)

[Shannon Parks]

Howdy Gents,

I'm mailing the last three ST35 Rev D boards to Triode Electronics this morning. I don’t plan on ordering any more of these. Since the company I had them fabricated at went under in 2008, I would have to redo the tooling at another company and the specs of this particular PCB make it an expensive board to manufacture. Indeed, the cost would almost double at the new PCB fabricator.

Instead, I will backtrack to my old supply of ST35 Rev C boards. These boards are functionally equivalent but will need a few slight changes to the BOM and manual. They look almost identical and have the same dims and will fit the same chassis. I will update the BOM & manual before I send anymore to Triode Electronics or sell any direct.

Warm Regards,
Shannon