OK, so the board is stuffed!
Next up is to finish off my chassis fine tuning. I have decided to go with the AC power inlet (mouser #161-0707-1-187) rather than the cord - this saves all that hassle with the "D" grommet. Just have to go widen that hole in the chassis for it, then I can prime, paint, and decorate.
I do have some wiring questions though. I saw on another DIY tube amp site about the virtues of twisting some wiring to avoid interference. I also noticed in the pics that Shannon posted that there was some kind of shielded wiring used there. Any guidelines or suggestions from the group on do's and do-not's for wiring?
-Michael